Horner-apg XL7 OCS User Manual download pdf (Page 2)

Specifications/Installation

MAN0971-02-EN

3. Installation Procedures

1. Carefully locate an appropriate place to mount the XL7. Be sure to leave enough room at the top of the unit for insertion and

removal of the microSD card. Also leave enough room at the bottom for the insertion and removal of USB FLASH drives

2. Carefully cut the host panel per the diagram on Page 1, creating a 189.7mm x 131.2mm ±0.1mm opening into which the XL7 may be

installed. If the opening is too large, water may leak into the enclosure, potentially damaging the XL7. If the opening is too small, the

OCS may not fit through the hole without damage.

3. Remove all Removable Terminals from the XL7. Insert the XL7 through the panel cutout (from the front). The gasket needs to be

between the host panel and the XL7.

4. Install and tighten the four mounting clips (provided in the box) until the gasket forms a tight seal (max torque 7-10 lb-in. [0.8 – 1.13

Nm])

5. Reinstall the XL7 I/O Removable Terminal Blocks. Connect communications cables to the serial port, USB ports, Ethernet port, and

CAN port as required.

4. Ports & Connectors

Page 2 of 7

1 2 3 4 5 6 7

No comments

Horner-apg XL7 OCS User Manual Page 2