Horner-apg XL7 OCS User Manual download pdf (Page 85)

XL7 User Manual

15.4 Configuration

An overview of configuration:

1. Start the configuration by selecting the Controller | I/O Configure menu item.

2. If the XL7 OCS is connected to the PC press the Auto Config System button to automatically

detect the Base model, I/O and any communication options.

3. If the XL7 OCS is not connected press the Config button to the right of the top of the unit. This

allows the base CPU to be selected.

4. Select either XL7 OCS Cscan from the type drop down box.

5. Once the type of XL7 OCS is selected, the model # drop down box will provide the XL7 OCS

model numbers from which to choose from.

6. Once the XL7 OCS CPU is selected, press OK to exit the dialog and configure the I/O that is

present in the first slot.

7. The I/O configure dialog (Specifically the Module Setup tab) provides 4 buttons to configure all

of the I/O. Go through each area of I/O and configure it.

8. Once done configuring the I/O OK out of configuration dialogs.

Configuring the XL7 OCS I/O has four main portions that are covered in this chapter. For additional

information on I/O, refer the chapters covering General I/O or High Speed I/O in this manual.

The four areas of I/O configuration are:

- Digital in / HSC

- Digital out / PWM

- Analog in

- Analog out

15.5 Digital Input / HSC Configuration

The following figure illustrates the Digital Input / HSC Configuration dialog.

Figure 15.3 – Digital Input / HSC Configuration Dialog

Page 85 of 110

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 109 110

No comments

Horner-apg XL7 OCS User Manual Page 85